Facts & Information

RV Lifts sells our products direct to the public. We do not use a dealer system to market our products. There is no dealer mark up or middle man involved. We leaned over 10 years ago that using salesmen is not the way to go and it saves you, our customer $500 to $1500. Because of our extensive knowledge of both motorhomes and motorcycles we prefer dealing directly with our customers who will actually use the product. While our products carry a one year warranty, we know from experience that extensive communications with our customers, reduces many potential problems and allows them to operate the product safely and correctly. We try to answer our phones 24 hours a day, 7 days a week to assist both our existing and potential customers.

The complete Rampage RV Lift system for motorhome use is $2895 complete, plus shipping expense to your location.We do not collect sales tax on any lifts shipped outside the state of Wyoming, saving you from $175 to $250. If we used a dealer network, which we do not, you would have to pay both the shipping and sales tax. The system for use in a pick up truck is $2595. In a pick up, no support system is required.

The loading surface of the Rampage RV Lift is larger, a full 18 inches, making it easier to load and operate. Any over sized motorcycle tire is no problem. The lift is capable of lifting 1000 pds although the motorhome may not be capable of carrying that much weight. Give us a call with your RV weight ratings and we will discuss your individual application.

The lift is locked into place when traveling. It rides about 18 inches above the level of the receiver on your coach or about 35” from the ground. Dragging is never a problem with our lift.

Two new receiver tubes are welded directly to the frame rails of your coach. Two structural steel support arms are then inserted into those receivers and held with hitch pins. These receiver tubes must be welded very securely as per our instructions and can be done by any good certified welder or anyone of our 130 experienced installers nationwide.

The lift system is then bolted or welded to the two support arms. The lift system can be removed very quickly for those times when you don't want to use it. Unlike other lifts, a bigger 2500 pd electric winch with a 15 ft remote switch is supplied to safely and easily load your bike. We supply the wiring to connect to your batteries or generator feed.

Because the RV Lift Rampage system loads from the side, the lift does not go up or down behind the motorhome, but lifts the motorcycle from the rear and side of the coach. NO other lift system available allows you to load or unload the motorcycle without disconnecting your tow vehicle. An extension receiver is added to your original receiver. You simply connect your tow bar or hitch ball to that receiver. You can "flat tow" another vehicle with no tongue weight up to 5000 pds and your towing from the motorhome, not the lift. A tow dolly can also be used for towing.

The RV Lift Rampage system can be installed on very few 5th wheel models but on NO travel trailers. At RV Lifts we turn away over 95% of our inquiries from 5th wheel owners.  The most common reason is that the 5th wheel does not have enough front hitch pin weight to compensate for the additional weight of the lift and motorcycle.  This problem is only getting worse as 5th wheel manufactures look to make their units lighter and motorcycles only seem to be getting heavier.  Please review the below chart to determine if your 5th wheel has the necessary front hitch pin weight for the size of the motorcycle you want to carry. Reinforcement of the frame rails which is usually required may increase the necessary front hitch pin weight required.

Please view all other pages on the website for additional information. Feel free to give us a call anytime 7 days a week with any questions you may have or to place your order. We accept checks, Visa, Master Card or Discover Card.